This website requires certain cookies to work and uses other cookies to help you have the best experience. By visiting this website, certain cookies have already been set, which you may delete and block. By closing this message or continuing to use our site, you agree to the use of cookies. Visit our updated privacy and cookie policy to learn more.
This Website Uses Cookies By closing this message or continuing to use our site, you agree to our cookie policy. Learn MoreThis website requires certain cookies to work and uses other cookies to help you have the best experience. By visiting this website, certain cookies have already been set, which you may delete and block. By closing this message or continuing to use our site, you agree to the use of cookies. Visit our updated privacy and cookie policy to learn more.
Three pre-engineered mounts simplify and speed dead shaft idler roll mount installation. The Quickie Mount can tolerate some degree of misalignment, such as mounting to an unmachined surface. These mounts often replace pillow block bearings, saving time and money. Split Flange Mounts are suited for between-frame mounting or mounting on a vertical surface. Supporting the shaft end rigidly, the Rigid Mount works best in applications using heavy loads and long-shafted rolls. The top half of the split flange and rigid mounts can be removed to change rolls without disturbing alignment. Pre-engineered mounts are available for all standard shaft sizes up to 2 inches.
Report Abusive Comment